Center mode

the center mode requires you to draw in two ways, depending on the selected class drawing process machine assisted box select a class, place a point at the front or back (center) of the object place another point at the opposite side of the object to set the length a cuboid should appear manual box select a class, place a point at the front or back (center) of the object place another point on the opposite side to set the length if you regret where you placed the second point, you can press shift , and the red arrow will appear again move the cursor to the side and click when you feel happy with the width a cuboid should appear if you wish to draw a manual box instead of with automation press shift while following the steps above special workflows signs (all tasks) drag the arrow across the longest side of the object dragging the arrow across the shorter side of the object will produce a small 3d box that doesn't include all points static objects (sequence tasks) objects that are considered static do not move throughout the sequence use the traffic light button to find and mark frames where static objects are not visible